An image of an Alex DM24 Rim 26 Inch (559 mm) with a black rim.

Highlights

26 inch, 24mm wide
Eyeleted spoke holes
Machined braking surface
Schrader valve compatible

Description

The tried and true Alex DM24 in 26 inch, 559 x 24mm. It is eyeleted, has a machined braking surface and is Schrader valve compatible, so it suits a straightforward 26 inch wheel build.

Weight is 665g with an effective rim diameter of 544mm for working out spoke length. A rim strip is not included.

Features

26 inch, 24mm wide. A 559 x 24mm rim, so it builds into a standard 26 inch wheel with common spokes and hubs.
Eyeleted spoke holes. Eyelets spread spoke tension into the rim, so the nipple seats are less likely to pull through under load.
Machined braking surface. The sidewall is machined flat, so rim brake pads bite evenly and the lever feel stays consistent.
Schrader valve compatible. The valve hole takes a Schrader valve, which is what most tubes at this size come with.
665g, ERD 544mm. Weight is 665g and the effective rim diameter is 544mm, so you can work out spoke length before you start the build.

Specifications

Wheel size: 26" (559mm)
Rim width: 24mm
Brake surface: Machined
Valve: Schrader compatible
Weight: 665g
Note: ERD 544mm. Rim strip not included.

Spoke calculator

Display

Pick the part it is laced to and we will give you the lengths to buy.

This rim

Looking up its measurements.

Check or change its figures

ERD effective rim diameter, from the spec sheet mm

Laced to which hub?

Find your hub

Or type its figures

Hub spacing locknut to locknut, 100 front or 110 rear on most BMX mm Same both sides front hubs, or matching flanges

Flange diameter spoke hole centre to the opposite hole centre. The drive side is the driver side, left or right hand drive alike, and is usually the bigger flange

Drive side mm Non-drive side mm

Flange position

Flange to locknut Centre to flange

Drive side mm Non-drive side mm