A tubeless-ready Radio Argon Pro Rim with white lettering on it.

Highlights

Fully flash welded join
Tubeless ready
Front and rear specific
315g per rim

Description

Radio design their rims in-house in Cologne, Germany, and the Argon Pro is the light one. It is fully flash welded and tubeless ready in 20" x 1.6" to 1.95" (406), and Radio spent a long time on the profile to push strength up and weight down. The result is one of the lightest pro alloy rims ever produced.

It comes in front and rear specific models, in 32 or 36 hole, 28mm wide and 315g either end. Made from 6061-T6 alloy and tested on the track for the past two years.

Features

Fully flash welded join. The seam is flash welded rather than pinned, which is part of what makes this a pro level rim.
Tubeless ready. The rim is built for tubeless, so you can set it up with or without a tube.
Front and rear specific. Available in front and rear models, so each end of the bike gets the rim designed for it.
315g per rim. One of the lightest pro alloy rims ever produced, at 315g front or rear.
Designed in Cologne, Germany. Developed in-house by Radio and tested on the track for the past two years.

Specifications

Wheel size: 20" x 1.6" to 1.95" (406)
Material: 6061-T6 alloy
Hole count: 32h or 36h
Rim width: 28mm
Weight: 315g front, 315g rear
Note: Flash welded join, tubeless ready. Sold as a single rim in front or rear specific models.

Spoke calculator

Display

Pick the part it is laced to and we will give you the lengths to buy.

This rim

Looking up its measurements.

Check or change its figures

ERD effective rim diameter, from the spec sheet mm

Laced to which hub?

Find your hub

Or type its figures

Hub spacing locknut to locknut, 100 front or 110 rear on most BMX mm Same both sides front hubs, or matching flanges

Flange diameter spoke hole centre to the opposite hole centre. The drive side is the driver side, left or right hand drive alike, and is usually the bigger flange

Drive side mm Non-drive side mm

Flange position

Flange to locknut Centre to flange

Drive side mm Non-drive side mm