A Tsquared Carbon Rim / Front, 406 x 25mm in size, featuring a silver, circular design with several small evenly spaced holes around its non-braking surface.

Highlights

Carbon rim, gloss finish
38mm deep section
406 x 25mm sizing
No braking surface

Description

The Tsquared front rim is carbon with a gloss finish. It is 406 x 25mm, so it laces into a standard 20 inch front wheel.

The section is 38mm deep and there is no braking surface, so this one is for a front wheel that runs no rim brake.

Features

Carbon rim, gloss finish. Carbon construction with a gloss outer, so the finish shows on the sidewall once the wheel is built.
38mm deep section. The deep profile means shorter spokes than a shallow rim, so work your lengths out before ordering.
406 x 25mm sizing. Standard 20 inch diameter at 25mm wide, so it suits normal 20 inch front tyres.
No braking surface. The sidewalls are not made for brake pads, so run this on a front wheel with no rim brake.

Specifications

Wheel size: 20 inch (406mm)
Material: Carbon
Finish: Gloss
Rim width: 25mm
Rim depth: 38mm
Brake surface: None
Note: Front rim. No braking surface, so not for use with a rim brake.

Spoke calculator

Display

Pick the part it is laced to and we will give you the lengths to buy.

This rim

Looking up its measurements.

Check or change its figures

ERD effective rim diameter, from the spec sheet mm

Laced to which hub?

Find your hub

Or type its figures

Hub spacing locknut to locknut, 100 front or 110 rear on most BMX mm Same both sides front hubs, or matching flanges

Flange diameter spoke hole centre to the opposite hole centre. The drive side is the driver side, left or right hand drive alike, and is usually the bigger flange

Drive side mm Non-drive side mm

Flange position

Flange to locknut Centre to flange

Drive side mm Non-drive side mm