Highlights

Low flange, low weight
3/8 inch female bolt axle
Common 6902 bearings
Takes press-on nylon guards

Description

The Cult Crew Front hub is a low flange, lightweight front BMX hub from Cult. The hub shell is made from 6061-T6 aluminum and boasts tiny micro flanges. The Cult hub press fit axle collars with press-on nylon hub guards.

Features

Low flange, low weight. Tiny micro flanges and a 6061-T6 aluminium shell bring the hub in at 266g.
3/8 inch female bolt axle. Runs a 3/8 inch by 24tpi axle with female bolts, so check your fork dropouts take that size.
Common 6902 bearings. Two 6902 bearings carry the wheel, and they are an easy size to find when it is time to replace them.
Takes press-on nylon guards. The press fit axle collars are made to accept press-on nylon hub guards.
Standard 100mm spacing. Measures 100mm locknut to locknut with a 38mm flange diameter and 17mm from flange to locknut.

Specifications

Width: 100mm locknut to locknut
Material: 6061-T6 aluminium shell
Bearings: 2 x 6902
Axle: 3/8" x 24tpi, female bolts
Weight: 266g (9.4oz)
Note: Flange diameter 38mm, flange to locknut 17mm

Spoke calculator

Display

Pick the part it is laced to and we will give you the lengths to buy.

This hub

Looking up its measurements.

Check or change its figures

Hub spacing locknut to locknut, 100 front or 110 rear on most BMX mm Same both sides front hubs, or matching flanges

Flange diameter spoke hole centre to the opposite hole centre. The drive side is the driver side, left or right hand drive alike, and is usually the bigger flange

Drive side mm Non-drive side mm

Flange position

Flange to locknut Centre to flange

Drive side mm Non-drive side mm

Laced to which rim?

Find your rim

Or type its figures

ERD effective rim diameter, from the spec sheet mm