An Eclat Cortex EVO FC Rear Freecoaster Hub, black with a metal axle and clutch internals, features "Cortex FC" and "3 Pin System" labels. It is shown against a white background.

The Eclat Cortex EVO FC Rear Freecoaster Hub is black, features clutch-style internals, includes two hub guards and axle bolts at both ends, and displays "Cortex" branding on the hub body.

Highlights

14mm male axle, 36 hole
9t clutch freecoaster driver
Slack you can adjust
Hub guards included

Description

The Cortex EVO is the updated version of Eclat's clutch style freecoaster, with improved bearing durability and a wider choice of slack settings. It runs a 14mm male hollow bore chromoly axle, a 9t driver and 36 hole drilling, on a 6061-T6 alloy shell.

The driver carries two bearings plus a bushing for extra support, and the 3 pin internals are aimed at smoother crankflip tricks. A Viper nylon hub guard and Gong driver guard are included, along with extra slack washers and a driver side cone washer for running without a guard.

Features

14mm male axle, 36 hole. A hardened heat-treated chromoly axle with hollow bore, drilled 36h, so it laces up to a standard BMX rear rim.
9t clutch freecoaster driver. The 3 pin clutch system lets you roll backwards without pedalling and is set up to make crankflips smoother.
Slack you can adjust. It arrives on the large slack setting with extra washers in the box, so you can dial the gap you like.
Hub guards included. Viper nylon hub guard and Gong driver guard come with it, plus a cone washer if you run without them.
Sealed bearings throughout. A 7905 and a 6002 in the shell with two 6802 in the driver, so grit stays out through wet winters.

Specifications

Material: 6061-T6 alloy refined hub shell
Bearings: Sealed, 7905 x1 and 6002 x1 in the hub, 6802 x2 in the driver
Driver: 9t, 3 pin clutch freecoaster system with CNC machined cones
Spokes: 36h
Axle: 14mm male hollow bore, hardened heat-treated chromoly, hex key inner axle
Included: Viper nylon hub guard, Gong driver guard, extra slack washers, driver side cone washer
Note: Large slack setting pre-installed. NDSPCD 51.5mm, DSPCD 56mm, flange to flange 57mm.

Spoke calculator

Display

Pick the part it is laced to and we will give you the lengths to buy.

This hub

Looking up its measurements.

Check or change its figures

Hub spacing locknut to locknut, 100 front or 110 rear on most BMX mm Same both sides front hubs, or matching flanges

Flange diameter spoke hole centre to the opposite hole centre. The drive side is the driver side, left or right hand drive alike, and is usually the bigger flange

Drive side mm Non-drive side mm

Flange position

Flange to locknut Centre to flange

Drive side mm Non-drive side mm

Laced to which rim?

Find your rim

Or type its figures

ERD effective rim diameter, from the spec sheet mm