A close-up of the Fit Bike Co Retro Front Hub, a gold-colored high flange bicycle hub with multiple spoke holes and a central axle secured by a nut, highlighting its classic retro design.

Highlights

High flange, 36 hole
Runs on sealed bearings
3/8 inch axle
100mm drop out spacing

Description

The Fit Retro is a high flange front hub in gold aluminium, drilled 36H for 14G spokes. It runs sealed bearings, so it keeps turning without much looking after.

The axle is 3/8 inch by 150mm and the hub is spaced for 100mm drop outs. That makes it a match for forks built around the smaller 3/8 inch axle.

Features

High flange, 36 hole. The high flange shell is drilled 36H for 14G spokes, so it laces up with standard spokes.
Runs on sealed bearings. Sealed bearings keep dirt and water out, so the hub spins on with little maintenance.
3/8 inch axle. The axle is 3/8 inch by 150mm, so it suits forks built for the smaller axle size.
100mm drop out spacing. The hub is spaced at 100mm, so check your fork spacing before you order.
Gold aluminium shell. The aluminium shell is finished in gold to suit a retro build.

Specifications

Fits: 100mm drop out spacing
Material: Aluminium
Bearings: Sealed
Hole count: 36H, drilled for 14G
Axle: 3/8" x 150mm
Colour: Gold

Spoke calculator

Display

Pick the part it is laced to and we will give you the lengths to buy.

This hub

Looking up its measurements.

Check or change its figures

Hub spacing locknut to locknut, 100 front or 110 rear on most BMX mm Same both sides front hubs, or matching flanges

Flange diameter spoke hole centre to the opposite hole centre. The drive side is the driver side, left or right hand drive alike, and is usually the bigger flange

Drive side mm Non-drive side mm

Flange position

Flange to locknut Centre to flange

Drive side mm Non-drive side mm

Laced to which rim?

Find your rim

Or type its figures

ERD effective rim diameter, from the spec sheet mm