Ikon Carbon Rim (No Braking Surface) / Black / Yellow / 20 x 1.1/8-3/8 / 36H

Highlights

Top shelf carbon weave
276g on the scales
451mm ETRTO race size
22mm wide, 426mm ERD

Description

20 x 1.1/8-3/8 This type of carbon is one of the top of the line carbon fibres produced today and this brand of carbon weave is the leader for producing hi-end products and is one of the most technological advanced fibres. IKON rims have a special matte finish on the rims, with glossy water decals, while using a “UD" Carbon Fiber Weave construction and guaranteed to turn heads every time you load the race rig into the gate.

Features

Top shelf carbon weave. Built with a UD carbon fibre weave from one of the leading brands of carbon, so the rim is light and stiff under power.
276g on the scales. At 276g it takes real weight off the outside of the wheel, which is where a racer feels it most.
451mm ETRTO race size. Sized 20 x 1 1/8 to 3/8 with a 451mm ETRTO, so it takes standard skinny race rubber.
22mm wide, 426mm ERD. A 22mm width and a 426mm effective rim diameter, so you can work out spoke length before you start lacing.
Matte finish, gloss decals. A special matte finish with glossy water decals, so the rim turns heads as you load the race bike into the gate.

Specifications

Wheel size: 20 x 1 1/8 to 3/8, ETRTO 451mm
Material: UD carbon fibre weave
Finish: Matte with glossy water decals
Rim width: 22mm
Valve: Presta valved tube required
Weight: 276g
Note: ERD 426mm

Spoke calculator

Display

Pick the part it is laced to and we will give you the lengths to buy.

This rim

Looking up its measurements.

Check or change its figures

ERD effective rim diameter, from the spec sheet mm

Laced to which hub?

Find your hub

Or type its figures

Hub spacing locknut to locknut, 100 front or 110 rear on most BMX mm Same both sides front hubs, or matching flanges

Flange diameter spoke hole centre to the opposite hole centre. The drive side is the driver side, left or right hand drive alike, and is usually the bigger flange

Drive side mm Non-drive side mm

Flange position

Flange to locknut Centre to flange

Drive side mm Non-drive side mm