An image of an Alex DM24 Rim 20 Inch (406 mm) with a black rim.

Highlights

20 inch, 24mm wide
Eyeleted spoke holes
Machined braking surface
Schrader valve compatible

Description

Tried and true, Alex DM24 20 inch x 24mm rims (406 x 24 mm).

Eyeleted, machined braking surface, Schrader valve compatible.

Rim strip not included.

Features

20 inch, 24mm wide. A 406 x 24mm rim, the standard 20 inch BMX size, so it laces into a normal wheel build.
Eyeleted spoke holes. Eyelets spread spoke tension into the rim, so the nipple seats are less likely to pull through under load.
Machined braking surface. The sidewall is machined flat, so rim brake pads bite evenly and the lever feel stays consistent.
Schrader valve compatible. The valve hole takes a Schrader valve, which is what most BMX tubes come with.
480g, ERD 390mm. Weight is 480g and the effective rim diameter is 390mm, so you can work out spoke length before you start the build.

Specifications

Wheel size: 20" (406mm)
Rim width: 24mm
Brake surface: Machined
Valve: Schrader compatible
Weight: 480g
Note: ERD 390mm. Rim strip not included.

Spoke calculator

Display

Pick the part it is laced to and we will give you the lengths to buy.

This rim

Looking up its measurements.

Check or change its figures

ERD effective rim diameter, from the spec sheet mm

Laced to which hub?

Find your hub

Or type its figures

Hub spacing locknut to locknut, 100 front or 110 rear on most BMX mm Same both sides front hubs, or matching flanges

Flange diameter/PCD (pitch circle diameter) spoke hole centre to the opposite hole centre. The drive side is the driver side, left or right hand drive alike, and is usually the bigger flange

Drive side mm Non-drive side mm

Flange position

Flange to locknut Centre to flange

Drive side mm Non-drive side mm