Avian Venatic Carbon Rim - 20x1-3/8in / Matte Black / 28H Front

Avian Venatic Carbon Rim - 20x1-3/8in / Matte Black / 28H Rear

Highlights

Carbon race rim, 320g
No braking surface
20 x 1-3/8" fitment
28 hole drilling

Description

The Avian Venatic carbon rim is typical of the Avian Brand, high quality and understated design and finish, but with high quality. Exactly our aesthetic here at LUXBMX, which is why we love their range of rims.

Manufactured from highest strength standard modulus fibre, not only are they light and stiff, but at 30mm wide and deep, these rims are low profile. This version of the rim has no braking surface, find them with a braking surface as well if you're running a disc set up.

Features

Carbon race rim, 320g. Highest strength standard modulus fibre keeps it light and stiff at 320g plus or minus 10g.
No braking surface. This version comes without a braking surface, with front and rear specific versions offered in the range.
20 x 1-3/8" fitment. 451mm rim that takes 20 x 1" through to 1-3/8" tyres, with a recommended maximum of 110psi.
28 hole drilling. 23mm wide with a 38mm dish and an ERD of 397mm, so you can work out spoke lengths before you lace.
Matte black UD weave. Understated finish that suits a low profile aero race build.

Specifications

Wheel size: 20" (451mm diameter)
Tyre size: 20 x 1-3/8" (fits 20 x 1" to 1-3/8" tyres)
Material: Highest strength standard modulus carbon fibre
Finish: Matte black UD weave carbon
Hole count: 28H
Rim width: 23mm
Brake surface: None
Pressure: 110psi recommended maximum
Weight: 320g +/-10g
Note: 38mm dish, ERD 397mm. Front (no braking surface) and rear specific versions are available.

Spoke calculator

Display

Pick the part it is laced to and we will give you the lengths to buy.

This rim

Looking up its measurements.

Check or change its figures

ERD effective rim diameter, from the spec sheet mm

Laced to which hub?

Find your hub

Or type its figures

Hub spacing locknut to locknut, 100 front or 110 rear on most BMX mm Same both sides front hubs, or matching flanges

Flange diameter/PCD (pitch circle diameter) spoke hole centre to the opposite hole centre. The drive side is the driver side, left or right hand drive alike, and is usually the bigger flange

Drive side mm Non-drive side mm

Flange position

Flange to locknut Centre to flange

Drive side mm Non-drive side mm